Close
|
|
|
|
What is a one-time-use part, and how do you determine if a fastener, clip, or part can be reused? These are questions that we are confronted with in the collision industry quite a lot. The other big question is "Where do I find this information?"
High-voltage (HV) vehicles have some special considerations for handling and storing HV batteries and other components. The dangers of HV batteries are potential even after removal which is why certain precautions are needed. Let’s see what Volvo has to say.
Additional Volvo position statements can now be accessed directly from the I-CAR RTS Portal. Let’s take a look at what these position statements include.
Volvo released an updated position statement that covers the subject of scanning and diagnostics. As with many other OEMs who have released similar position statements, Volvo’s statement explains when to scan, what vehicles require scanning, and information that supports their position.
While searching for information on advanced driver assistance systems (ADAS) on an OEM repair information site, you may come across unique calibration procedures or events. These events can vary by year and model, even within a particular make. As the RTS team has been researching these systems, we have been identifying these atypical circumstances. In order to help you better understand them, we are putting together a series of articles that help with the repair and calibration of ADAS. Let’s take a closer look at Toyota/Lexus vehicle control history codes.
Day four of the numerous I-CAR and SCRS interviews and presentations at the 2024 SEMA Show.
Day three of the numerous I-CAR and SCRS interviews and presentations at the 2024 SEMA Show.
Day two of the numerous I-CAR and SCRS interviews and presentations at the 2024 SEMA Show.
Day one of the numerous I-CAR and SCRS interviews and presentations at the 2024 SEMA Show.
I-CAR had a discussion on consideration for steering column inspection after a collision.
Are you looking for OEM emergency response guides (ERGs)? The Repairability Technical Support (RTS) team has located these guides and either houses them on the RTS website, provides links to webpages that house them, or provides articles with instructions on how to locate them.
Sometimes, going back to the basics can make the difference between a quality repair and a failed repair. When replacing stationary glass, there are extra considerations to perform a complete and quality repair.
What is a one-time-use part, and how do you determine if a fastener, clip, or part can be reused? These are questions that we are confronted with in the collision industry quite a lot. The other big question is "Where do I find this information"?
As part of the I-CAR Repairability Technical Support (RTS) OEM linking pin activity, we are helping to connect the collision repair industry to the vehicle makers. A common question when it comes to Toyota/Lexus sectioning, can alternate cut locations be used? We reached out to Toyota for clarification.
Park assist sensors are part of the park assist system, just one of many advanced driver assistance systems (ADAS) found on vehicles today. Damaged sensors are typically replaced and may require painting to match the vehicle. Vehicle makers often provide information on the painting of new sensors. Some vehicle makers do not recommend refinishing sensors with minor finish damage because excessive paint thickness may adversely affect the operation of the park assist system. However, other vehicle makers allow refinishing and provide guidelines. Let’s see what Jaguar Land Rover (JLR) has to say.
